solar led wall light with sensor IP65 waterproof outdoor new design
product Features:
High tensile die-casting aluminum light body, anti-corrosion,
Excellent heat dissipation.
Installation type: post top mounting & Side entry mounting.
LED Luminous efficiency reach up to 190lm/w. 2000lm-8000lm
available.
Light distribution: TYPEII for road lighting, TYPE III for area
lighting.
Mounting Height for Best Visibility: 13 to 26 ft (4 to 8m).
Solar panel can be adjustable manually in vertical and horizontal
direction, ensure maximum efficiency of solar energy
Prdduct application:
1. Temples or traditional spaces.
2. Wiring no-needed places.
3. Sports playgrounds, rural roads.
4. Pathways, trailways.
5. Entrances, exits, muster areas.
6. Outside storage areas, perimeter lighting, etc.
Product advantages:
1. 4-5 continuous days of anti-could and rain;
2. Discharge time: 8-10 hours/day;
3. The product can work normally without the sunshine. The Glim
smart technology
can generate micro electricity in low light, such as blue light,
red light and purple light;
4. All in one light products. Soalr panel, lamp and storage battery
are integrated;
5. Remote positioning, remote control, single light control, multi
light control, etc.
6. The total cost is about 40% lower than the traditional solar
lamp. The product no
longer needs any maintenance after installation, and adopts a
one-time
consumption hosting model to benefit customers for all life.
FAQ:
1. What are the information you should give us to best customize
our solar lights?
(1) Please tell us where the products are installed.
(2) How many continuous rainy days in the raining season there?
(3) The height and width of the light casting area.
2. What is the typical maintenance schedule for a solar light
system?
There is no maintenance schedule for customers, because the solar
light products
are not required for that.
3. What happens if there are cloudy days?
Electrical energy is stored in the battery each day, and some of
that energy is used to operate
the light at night. Generally, the system we design would allow the
battery operate the light
for seven nights without charging.
4. How does the light know when to turn on and turn off?
Bright New Energy's solar controller uses a photocell or timer to
control when the light should turn on or turn off.
The photocell detects if the sun comes up or goes down. The solar
controller utilizes an internal timer that is
pre-set for a specific time to determine when to switch the light
off.
5. How many hours need to install solar LED street light?
The complete installation will not take longer than 2 hours if done
properly and stepwise.
6. What is a sun hour?
A sun hour is a unit of measurement of the intensity of sunlight on
the earth at a given time
that can be used for generation of solar power, recognizing factors
such as climate and weather.
A full sun hour is measured as the intensity of sunlight at noon,
whereas less than a full sun
hour will result during the hours before and after noon.
